As our VWs get
older it will eventually begin to lose oil pressure. And we may notice
that our oil light comes on earlier near idle, and takes longer to go
off as we accelerate.Some might think that this is the oil pump is going
bad. This is rarely the case. As the engine wears, all of the oil clearances
grow larger, and the oil flows through the bearings (etc.) with much less
resistance, and the result is less oil pressure. Of course the ultimate
or eventual solution is to rebuild the motor.
Nonetheless our engine may be running fine, and still has some life left in it. Yet some are annoyed by that flickering oil light, so they decide to go with a larger oil pump for the present. Here is where we need a little education on oil pumps. While they may look about the same, and will fit into the case, there are differences that matter.
Nonetheless our engine may be running fine, and still has some life left in it. Yet some are annoyed by that flickering oil light, so they decide to go with a larger oil pump for the present. Here is where we need a little education on oil pumps. While they may look about the same, and will fit into the case, there are differences that matter.
The oil pump
is driven by engaging in a notch in the end of the camshaft.
This puts the
oil pump body in very close proximity to the 3 rivets or bolts that hold
the camgear to the shaft in the 40 HP 1200cc and 50HP 1500cc motors.
If you were
to try to install the larger volume stock oil pump from the 1600 cc motor
you would find that it hits the bolts.
In the 1600cc
motor there are 4 rivets in the gear that have been moved outward and
the gear is dished to allow room for the deeper pump body.
The 1200cc motor
could benefit from the 20% larger pump from the 1500cc motor, but the
1500cc and 1600cc motors have to use heavy duty aftermarket pumps for
more volume.
These are readily
available. Another thing we need to be aware of is that the high performance
camshafts all use the older style 3 bolt flat cam gear.
This means
that even the stock pump will no longer work, and a heavy duty pump made
for that application has to be used.
Keeping this
little bit of information in mind could save you time and trouble if you
are upgrading your oil pump. Just a note: Using a heavier straight weight
oil could also bring that oil pressure up a little.
Rick Higgins
and Crew
Bug Me Video, Inc.
Bug Me Video, Inc.
0 comentarios:
Publicar un comentario